After locating the fuse block near the firewall, it was fastened in place. The wires were then separated and moved to their respective locations.
Next, I went to work on the headlights. I began by fitting the new rubber gaskets behind the headlight buckets and fastening them to the opening in the fender.
After the buckets are fastened in place the inner rim is mounted to the bucket. I replaced the adjusters, wiring and springs on both headlights just to eliminate any future problems.
Finally the headlights are positioned, just to make sure they fit properly. The finish paint has not been applied yet so the headlight assemblies must be removed.
These headlights are really cool. The signal lights are actually inside the headlight itself. If you look closely, you can see the small amber bulb just below the center of the bulb.
The car will also have driving lights. They will be located in the grille area.
Stay tuned,
Tom McCurry
These headlights are really cool. The signal lights are actually inside the headlight itself. If you look closely, you can see the small amber bulb just below the center of the bulb.
The car will also have driving lights. They will be located in the grille area.
Stay tuned,
Tom McCurry